Welch Allyn 23120P (PAL) CompacVideo Otoscope - User Manual User Manual
Welch Allyn Equipment
This manual is related to the following products:
Table of contents
Document Outline
- CompacVideo Otoscope
- Introduction
- Symbols
- IPXØ
- Safety & Warnings
- Setup
- 1. Attach the Video Otoscope Head to any 3.5V Welch Allyn rechargeable battery handle. DO NOT ATTACH TO A WALL TRANSFORMER.
- 2. With the power off, connect the video cable (supplied) to the output on the back of the Video head.
- 3. Connect the other end of the video cable to the “Input” or “Video In” on the video monitor, VCR, or other composite video input.
- 4. Attach a Welch Allyn (4 mm) speculum, provided with the system, to the video head by rotating clockwise. The quality of the video image will deteriorate if other speculum are used.
- 5. Turn on the power switch on the monitor.
- 6. Turn the rheostat on the power handle to FULL POWER. For optimum performance, the Video System should always be used with the...
- Using The CompacVideo Otoscope System
- Lamp Replacement
- Battery Replacement
- 1. Unscrew bottom cap.
- 2. Shake out old battery.
- 3. Insert replacement battery Important: Please note battery polarity (see figure).
- 1. Only a Welch Allyn Battery is to be used. Do not use any other non-rechargeable battery.
- 2. Batteries must be removed prior to disposal of product.
- 3. Used batteries are to be disposed of safely and in accordance with local disposal requirements.
- 4. If leaking batteries are encountered, use protective equipment when handling batteries to avoid contact of battery fluids with the skin. Then dispose of batteries safely in accordance with local
- Specifications
- Cleaning & Storage
- Replacement Parts:
- Limited Warranty