Vinten Radamec Head Processing Module (HPM) - Manual (Page 4)

2
Safety & Warnings
Important information on the safe installation and operation of this
product. Read this information before operating the product.
For your personal safety, read these instructions. Do not operate
the product if you do not understand how to use it safely. Save
these instructions for future reference.
Warning Symbols Used in these Instructions
Intended Use
Do not use this product for any other purpose than that specified in this
usage statement. The Vinten Radamec HPM is designed for use in
television studios to interface with the Vinten Vision 250E pan and tilt
head and Quattro SE pedestal for use with studio VR systems.
The HPM is intended to be used by television camera operators within
an indoor studio environment. Do not attempt to use this product if you
do not fully understand how to operate it.
Electrical Connection
Safety warnings and cautions are included in these
instructions. These safety instructions must be followed to
avoid possible personal injury and avoid possible damage to
the product.
WARNING!
Where there is a risk of personal injury or injury to others,
comments appear supported by the warning triangle symbol.
Where there is a risk of damage to the product, associated
equipment, process or surroundings, comments appear
supported by the word ‘Caution’.
ELECTRIC SHOCK
Where there is a risk of electric shock, comments appear
supported by the hazardous voltage warning triangle.
WARNING! Risk of electric shock. Always disconnect and
isolate the product from the power supply before attempting
any servicing or removing the covers.
WARNING! Risk of electric shock. Always check cables
for signs of damage. Damaged cables can cause personal
injury and/or damage the equipment.
WARNING! The external DC PSU used must be approved
to IEC 60950-1, 2nd edition, and have a power output
limited to the requirements of the equipment.
CAUTION! This product must be connected to a power
supply of the same voltage (V) and current (A) as indicated
on the product. Refer to the Technical Specifications for the
product.
CAUTION! All connections to other devices must be made
using shielded cables.
CAUTION! We recommend that you use the power supply
cable supplied with the product.
CAUTION! Using alternative power sources will invalidate
the system EMC liability.
CAUTION! Do not exceed the current output limit of the
product when powering auxiliary devices.
CAUTION! Always use a fuse of the correct type and rating
for the product. Refer to the Technical Specifications for the
product.