Vinten Radamec Head Processing Module (HPM) - Manual (Page 11)

9
Installation
Electrical Connections
Power Options
Cable Clamp
Unscrew the cable clamp knob sufficiently to feed the cables into the
channels through the cable clamp block. After all the cables have been
fitted tighten the cable clamp knob back down to secure.
CAUTION! Do NOT attempt to power other external
devices other than those specified from the HPM power
output socket. The HPM may be damaged if any device
other than the Quattro SE pedestal is connected.
CAUTION! Using alternative power sources will invalidate
the system EMC liability.
POWER SOURCE HPM DC OUTPUT
AC power via the
HPM PSU
Available to supply the
Quattro SE
DC power from the
camera using a
standard 4-pin XLR
power cable.
Limited by the DC
power specification of
the camera
CAUTION! All cables must be secured and dressed using
the cable clamp to minimise the risk of damage.
1
2
3
1. . . . . . . .Cable clamp knob
2. . . . . . . Cable clamp block
3. . . . . . . . . .Cable channels