Vinten Radamec Head Processing Module (HPM) - Manual (Page 10)

8
Installation
Mounting the HPM
To mount the HPM to a Vision 250E head, any fitted payload must be
removed and it must be dismounted from its support. All work should
be carried out in a workshop environment on a suitable work surface.
Note: When fitting a Vision 250E/HPM configuration to a Quattro SE
pedestal, ALWAYS fit the adaptor ring kit (part no. 3354-900SP)
between the head and the pedestal weight tray to avoid trapping
the Ethernet, power and genlock cables.
The head should be placed on its side or camera mounting plate to
allow access to the base of the mounting plate area, then proceed as
follows:
On completion, mount the head back on to its support, together with the
camera and other accessories. Re-check the balance of the head and
adjust as required.
x4
2 mm
1
WARNING! Do not attempt to lift or carry the head by using
the mounting bracket or the HPM.
2
A
B
B
A
M3 x 12 mm
M3 x 35 mm
A
B