Vinten Radamec Fusion FCS-16 - Manual (Page 24)

22
2. Select the desired studio datum from the list on the right-hand side.
3. Select EDIT.
4. Re-type a name for the datum, and or re-enter the X and Y coordinates (in millimetres) as required.
5. Select OK
6. Select the ‘X’ in the top right-hand corner to close the application window.
Delete a datum
To delete a studio datum, proceed as follows:
1. Select the CONFIGURATION MANAGER short-cut icon on the touch screen desktop.
(Alternatively, select START > PROGRAMS > VITEC CAMERA DYNAMICS > FUSION ROBOTIC SYS-
TEM > CONFIGURATION MANAGER)
2. Select the desired studio datum from the list on the right-hand side.
3. Select DELETE.
4. Select the ‘X’ in the top right-hand corner to close the application window.
Run the VRC program
To run the VRC system application, proceed as follows:
1. Select the VRC SERVER short-cut icon from the touch screen desktop.
(Alternatively, select START > PROGRAMS > VITEC CAMERA DYNAMICS > FUSION ROBOTIC SYS-
TEM > VRC SERVER)
2. Select the VRC CLIENT short-cut icon on the touch screen desktop.
(Alternatively, select START > PROGRAMS > VITEC CAMERA DYNAMICS > FUSION ROBOTIC SYS-
TEM > VRC CLIENT)
3. Select a user name from the list.
4. Enter the password.
5. Select OK.
Target camera units
Connected camera units must be ‘targeted’, that is reference the absolute studio datum (Fig 5) (Fig 6), before
they can be used to either store shots in a show or move to shots already stored in a show. RP2A pedestals
will automatically reference their target, whereas both Fusion FP-145 and SP-2000 pedestals must be targeted
by the operator.
To target a Fusion FP-145 or SP-2000 camera unit, proceed as follows:
1. Select the camera unit to be targeted (10).
For more detail on camera selection refer to Select a camera on page 25.
2. Use the pedestal joystick (16) to position the Fusion FP-145 camera unit next to a (Fusion) studio da-
tum target as shown in (Fig 5), or use the pedestal joystick (16) to position the SP-2000 camera unit
central to a (SP-2000) studio datum target as shown in (Fig 6).
For more information regarding positioning a pedestal, refer to Pedestal control joystick on page 26.
3. Select OPTS (25) > TARGET.
4. Select the relevant target from the list and select OK.