beautypg.com

Safety, Pre-installation check, Installation – Vintage Cellars Wine Guardian Humidifier Manual User Manual

Page 9

background image

9

Safety

The Wine Guardian Humidifier uses only 24-volt power. However, that power comes from a
transformer, which uses 120-volt power. Therefore, before servicing the humidifier, be sure to
disconnect the main power to the cooling unit or to the humidifier.

The water supply to the humidifier may be hot. Turn off the humidifier and allow the water to
cool before servicing the humidifier.

METAL EDGES CAN BE SHARP AND CAUSE INJURY IF NOT HANDLED PROPERLY.

FAN BLADES CAN ALSO BE SHARP. DO NOT PUT FINGERS OR OTHER OBJECTS

INTO A MOVING FAN.

Installation

HUMIDIFIER MAY NOT BE INSTALLED WHERE IT MIGHT BE EXPOSED TO FREEZING

TEMPERATURES. IF THE COOLING UNIT IS MOUNTED OUTSIDE, THE HUMIDIFIER WILL HAVE TO

BE MOUNTED IN THE SUPPLY DUCT TO THE CELLAR INSIDE THE BUILDING OR MOUNTED AS A

FREESTANDING UNIT INSIDE THE CELLAR.

Pre-Installation Check

To check for any possible non-visible shipping damage, you may wish to test the unit before
actually installing it. To do so, remove the unit from its packaging and set it on any sturdy level
surface. If a freestanding unit, plug in the unit. If the unit is to be mounted into a cooling unit,
you need to wire the humidifier to the cooling unit and the cooling unit must be turned on. Then
turn on the rocker switch on top of the humidifier. The switch light should come on. This
indicates the unit has power. Set the humidistat above the room humidity. The unit should now
come on. The water solenoid should open and the fan should come on. Listen for any unusual
noise or vibration. Turn the humidistat below the room condition and the unit should go off.

 NEVER MODIFY THIS EQUIPMENT. CHANGES OR MODIFICATIONS MAY VOID THE

WARRANTY, CAUSE DAMAGE TO THE EQUIPMENT, AND/OR CREATE A SAFETY
HAZARD.

 NEVER PLACE ANYTHING ON TOP OF THE UNIT. NEVER BLOCK OR COVER ANY OF THE

OPENINGS OR OUTLETS OF THE UNIT.

 NEVER ALLOW ANYTHING TO REST ON OR ROLL OVER THE POWER CORD, AND NEVER

PLACE THE UNIT WHERE THE POWER CORD IS SUBJECT TO WEAR OR ABUSE.

 DO NOT REMOVE OR OPEN ANY ACCESS DOOR OR COVER UNLESS THE UNIT IS

UNPLUGGED.

CAUTION

CAUTION

DANGER

This manual is related to the following products: