Vintage Cellars Wine Guardian Humidifier Manual - Manual (Page 10)

10
Free Standing Installation with Stand-Alone Model
Figure 4.0
Stand-Alone Installation
1) Mount the face grille onto the humidifier box so that the separation plate slides in on top of
the fan and between the insulation on the sides. The two metal tabs (top and bottom) should
slide in between the insulation and the metal wall. Install two screws (top and bottom) into
the metal tabs to secure the grille in place.
2) Determine where unit will be mounted.
a. If wall mounted, use metal bracket provided. Secure bracket to wall with small hole on
top, larger hole on the bottom. Install humidifier onto the bracket with drain tube on
bottom. Secure the bracket to the humidifier at the top using the screw provided.
b. If shelf mounted, drill a 1” diameter hole in the shelf and mount humidifier with the drain
on the bottom through the hole.
c. If through-the-wall mounted, frame opening to fit outside dimension of unit. Allow for
drain line, flanges and water line. Slide unit into opening and secure into place (flanges at
front can be used). Fill in any gaps between the humidifier and the wall framing with
insulation.