Universal Remote Control (URS) THZ-100 Rev 03 - Manual (Page 39)

Page 35
THZ-100 T
HERMOSTAT
Press the key below the OK key label in the smart-key label at the
bottom right of the display to change your settings. If you decide to
cancel the operation then press the key below the Go Back key
label in the smart-key label at the bottom left of the display.
The new screen display shows the value that you have selected to
change. Use the Up and Down arrow keys to the right of the
display to select your new value. When you are satisfied with your
new selection, press the key below the Set key label
Discovery Mode
The Discovery Mode selection in the Options screen is used to
establish communications between the THZ-100 thermostat and the
MRX Advanced Network System Controller unit for initial setup of
the thermostat and any required updates. This is not used in normal
operation.