Universal Remote Control (URS) THZ-100 Rev 03 - Manual (Page 13)

Page 9
THZ-100 T
HERMOSTAT
At the bottom of the screen is a smart-key label to identify the current
function of the push button located directly below.
Changing the Mode (Cool, Heat, Auto, Off)
To change the mode of your HVAC system equipment between Cooling,
Heating, Auto (system will automatically change between cooling and
heating) or OFF enter the Options menu then access the Climate Modes
sub menu as described below.
Changing the Heating Temperature (Temperature Override)
To change the current heating temperature, press the Up or Down arrow
key on the thermostat. The thermostat screen shows the current temperature
on the left side and the desired temperature on the right side of the display.
Press the Up and Down arrow keys to set your new desired heating
temperature to override the programmed value. To save the new desired
value, press the key below the Set Tempkey label in the smart-key labeled
Set Temp at the bottom right of the display. You can also save the new
desired temperature by simply allowing the display to time out while the
current and desired override temperatures are displayed.
If you decide to cancel the operation, press the key below the Cancel key
label in the smart-key label at the bottom left of the display.
This places the thermostat in the Override mode. While in this mode, the
thermostat holds your new temperature selection until the next regularly
scheduled time period in your pre-programmed HVAC schedule.