Universal Remote Control (URS) THZ-100 Rev 03 - Manual (Page 28)

Page 24
THZ-100 T
HERMOSTAT
Accessing Temperature Sensor Information
If you desire to view the status of all temperature sensors used in
your system then use the arrow keys to move the highlight bar to
Sensors.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this new information screen. If
you decide to cancel the operation then press the key below the Go
Back key label in the smart-key label at the bottom left of the
display.
If you select OK then the display changes to a list of temperature
sensors used in your system. The first list entry is the thermostat’s
onboard sensor. The right side of the screen shows the current
reading for that sensor.
The second list entry is any wired sensor in the system. The name
of the sensor is displayed with the current reading to the right. If
there is no wired sensor in your system then this line is not displayed.
The last list entry is any local temperature information accessed
from the internet. The name of the sensor is displayed with the current
reading to the right. If there is no internet temperature available to
your system, then N/A is displayed.