Universal Remote Control (URS) THZ-100 Rev 03 - Manual (Page 31)

Page 27
THZ-100 T
HERMOSTAT
How To Set The Heating 2nd Stage Offset
If you desire to change the heating 2nd stage Offset temperature then use
the arrow keys to move the highlight bar to Heating (2nd Stage Offset). If
you do not have a multi-stage heating system then the Heating (2nd Stage
Offset) feature is not displayed in the menu list.
Press the key below the OK key label in the smart-key label at the bottom
right of the display to select this option. If you decide to cancel the operation
then press the key below the Cancel key label in the smart-key label at
the bottom left of the display.
After pressing OK the screen updates to a screen that says Heating 2nd
Stage Offset at the top of the screen and the current offset temperature in
the center of the screen. Use the arrow keys to adjust the temperature up or
down to the value you desire.
Press the key below the Set Temp key label in the smart-key label at the
bottom right of the display to save your new offset value. If you decide to
cancel the operation then press the key below the Cancel key label in the
smart-key label at the bottom left of the display.
The initial value is established when the thermostat is initially setup through
the MRX Advanced Network System Controller.