ThingMagic Nomad RFID Setup Guide - Manual (Page 10)

10 Nomad RFID Reader Setup Guide
RFIDSearchLightInstaller.CAB window
The installer installs the following files:

RFIDSearchLightInstaller.CAB

RFIDSearchLight.CAB

FtdiVcpInstaller.CAB

NETCFv35.Messages.EN.wm.CAB

NETCFv35.wm.armv4i.CAB
After each component is installed, you have to press
“OK” in the top-right hand corner to install the next
component.
NOTE: You must restart the Nomad after installation.
7. After each component is installed, click on the OK button in the upper right of each
window. When the process completes, you must the restart the Nomad.
8. Click on the Start button in the Windows main menu. The Start dropdown menu
displays.
9. Plug the RFID Reader’s USB cable into the Nomad.
10. Go to the Before Running the RFID SearchLight Software , before using the RFID
SearchLight application.
Nomad connector panel (bottom of unit) With RFID Reader connected to USB port.