Thetford Tecma X-Light - Manual (Page 4)

Operating instructions for incorporated bidet
Open the single level tap and adjust the temperature.
At the end, press the discharge button in order to clear out.
The discharge button must be pressed before the bowl is completely full.
Water level regulation
Control panel with one switch
When the toilet isn't used, the water level must be 1 cm above the outlet hole in the
ceramic bowl.
Anyway for different installation condition water level adjustment could be required.
If so, turn the shaft trimmer in the rear part of the control panel, up to adjust the level
at 1 cm. above the outlet ceramic hole.
Control panel with two switches
From stand by position (when the bowl is completely empty), pressing "before use"
button the bowl will be automatically filled up to the correct water level at 1 cm.
above the outlet hole in the ceramic bowl.
Anyway for different installation condition water level adjustment could be required.
If so, turn the shaft trimmer in the rear part of the control panel, up to adjust the level
at 1 cm. above the outlet ceramic hole.
3