Smart Power Systems Liberator Series - Manual (Page 32)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 31 of 54
6. If the system controller has been set to “auto-start”, the generator will begin to
produce power whenever the PTO is engaged. See installation instructions for the
directions to select the “auto-start” options.
7. Additional
Information provided by the Command & Control Center:
a. When the Command & Control Center is in Normal mode, pressing the Mode
switch once will display the oil temperature (reference Figure 19).
Displayed Oil
Temperature in degrees
Fahrenheit
Example of oil temperature display
Figure 19
b. When the Command & Control Center is in Normal mode, pressing the Mode
switch twice will cause the amount of time since the oil filter was last changed to
be displayed (reference Figure 20):
Time Since last Oil Filter
Change in Hours.
Example of oil filter run time display
Figure 20
c. When the Command & Control Center is in Normal mode, pressing the Mode
switch three times will cause the configuration of the generator system controller
to be displayed. The “
LI” indicates the controller is configured to run a
Liberator
™
system, and the number displayed corresponds to the maximum