SINGER S10 STUDIO Instruction Manual - Manual (Page 11)

11
z
z
x
x
c
c
vb
v
b
q
w
e
r
t
Threading the Machine
Step z
raise the presser foot lifter. Bring needle up to its
highest position. draw the loose end of the thread
under the thread guide with your left hand, as you
hold the thread near the spool with your right hand.
then draw the thread down through the right
channel of the thread tension dial.
q thread guide
Step x
Firmly draw the thread around the thread guide plate
and up to the thread take-up lever.
w thread guide plate
Step c
Slip the thread from back to front through the slit and
towards the eye of the take-up lever as shown. the
thread tail should be on the left side of the take-up
lever.
e Slit
r eye of the take-up lever
Step v
Pull the thread towards the lower thread guide.
Step b
Slip the thread in the needle bar thread guide from
the left.
t needle bar thread guide
thread the needle from manually front to back or use the
built-in needle threader.
NOTE
refer to page 12 for information about how to use the
built-in needle threader.
Complete Threading Diagram for Upper Thread
See diagram at left.