SINGER 14T967DC QUANTUMLOCK - Manual (Page 62)

61
Cut out approximately 2cm (51/64 inch) from the corner,
in line with the overedge seam edge.
Sew one stitch beyond point (A) and stop.
Raise needle and presser foot.
Pull the fabric to the rear of the machine just enough
to release the thread caught on the finger of the needle
plate.
Note: Presser foot has been removed to show detail.
Turn the fabric and lower the presser foot so that the
knife is positioned in line with the cut edge.
Pull slack threads up, then start to sew.
Turning Square Corners
Fold the fabric with the wrong sides together and sew.
Press the pin tucks in the same direction.
(1) Outside Corner
Cutting line
Cutting line
Cutting line
A
A
Knife
2 cm
2 cm