SINGER 14T967DC QUANTUMLOCK User Manual
Page 58

57
To Secure the Rolled Hem Thread Chain
Hold the thread chain when you begin sewing to
keep it from curling into the seam.
Additional Information About Rolled Hemming
Apply a small drop of liquid seam sealant to the
end of the seam. Allow to dry, then cut the chain
close to the stitches.
Note: Test the liquid seam sealant for color
fastness before use.
Place a slight tension on the material in the sewing
direction and a finer seam finish can be obtained.
The minimum overedge stitch width that can be
obtained for rolled hemming is approximately
1.5 mm (1/16 inch) since the cutting width cannot
be set below 3.5 mm (9/64 inch).
This manual is related to the following products: