Rice Lake SURVIVOR LaserLight Series Remote Display - ConnexLink Wireless Radio 900 MHZ Installation - Manual (Page 2)

2 ConnexLink Option Installation Instructions
The ConnexLink Wireless Radio system can be installed in the 4", 6" or 4-SG Laserlight Remote Displays. Use
the following steps to install the ConnexLink Wireless Radio option.
WARNING
Some procedures described in this manual require accessing the inside of the remote display enclosure.
These procedures are to be performed by qualified service personnel only.
1. Loosen screw on the bottom of the remote display.
2. Pull the chassis from the enclosure as far as it will go. There are tabs to keep it from coming all the way
out.
Loosen All Screws
Pull body from
enclosure until tabs
meet enclosure
frame.
Figure 2. Opening the Remote Display
3. Remove the main power supply wire harness.
4. Install new power supply harness in the same location.
5. Secure harness with the cable tie included at the location shown in Figure 3.
Remove existing power
supply harness.
Install new power
supply harness. Secure to panel with
cable tie at cable tie
location on the panel.
Figure 3. Replace Power Cable Wire Harness