Rice Lake Stationary Livestock Scale - MAS-LC - Operators Manual - Manual (Page 9)

Assembly and Installation 5
2.2 Permanent Installation
Assembly of the MAS-LC at its permanent location is recommended. As with any weighing equipment, the
accuracy of the scale is dependent on the installation. In all installations, the scale must be level to ensure proper
operation.
Rice Lake Weighing Systems recommends a concrete foundation (piles or piers) for permanent installations. The
foundation must be able to support the gross weight of the scale (scale dead weight plus scale capacity), and the
piles or piers must be situated directly under the load cell stands (see shimming location in Figure ). The foundation
must not be subject to distortion or motion due to frost action. A qualified local professional should be consulted to
recommend the proper size of foundation for the location. Foundation dimensional requirements are available from
the dealer or Rice Lake Weighing Systems. Requirements may vary from one Weights and Measures jurisdiction to
another, please contact the local office.
2.2.1 Install
1. Place base frame on a firm surf ace that is straight, plumb and level.
2. Remove overload bolts.
Load cell stand cover
must fit squarely into
load cell stand before
removing overload bolts.
Improper fit will cause the
scale to weigh loads incorrectly.
Base of scale must be set on a firm level surface.
Remove overload bolts
after frame is set.
Important Retain overload bolts and nuts load cell replacement and/or future relocation of the scale.
Figure 2-2. Scale Base Frame and Overload Bolts
3. Install the two internal upright assemblies and the two gate upright assemblies to the base frame using the
hardware provided. See Figure 2-3.
Important
Do Not tighten hardware at this time, it will need to be loose to allow for wall panel installation.
Upright and wall installation should be done with 2 people or an overhead crane.