Rice Lake MSI4300 PortaWeigh Plus Crane Scale 7 Key - Manual (Page 18)

MSI-4300 Porta-Weigh Plus/7 Key • User Guide Page 17
M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L
Action:
1) Press SHIFT & SETUP to enter the Setup menu. The
message describes the parameter being set. To change the
setting of the parameter push ENTER . Options are viewed
by repeated pushing of the SELECT key. Selections are
stored with the ENTER key. Pushing the CLEAR key will
skip all remaining parameters and return the scale to normal
operation. Pushing the POWER key will also exit the setup
mode (and turn off the power).
Note: Not all the selections below are activated on every Porta-Weigh
Plus. Legal-for-trade issues and application issues require certain
menu items to be under the Calibrate menu (under seal, see calibration
section), and certain items to be disabled. Any or all menu items can
be eliminated under software control (contact factory for details).
Top Menu Sub-Menu Selections (highlighted selections are defaults)
FILTER LOW, MEDIUM, HIGH
UNITS POUNDS, KILOGRAM, TONS, METRIC Tons
AUTO OFF ENABLED, DISABLED
REMOTE ENABLED, DISABLED
LIGHTING AUTOmatic On, Off
CONTRAST (eight steps with message numerics at "123456")
HI SET PT HI VALUE Set value
MODE GROSS, NETGROSS, DISABLE
RESPONSE NORMAL, BLANK LCD, BLINK LCD (and Backlight)
EXIT? (exit Setpoint sub-menu)
LO SET PT LO VALUE Set value
MODE GROSS, NETGROSS, DISABLE
RESPONSE NORMAL, BLANK LCD, BLINK LCD (and Backlight)
EXIT? (exit Setpoint sub-menu)
TOTALIZE MANUAL, AUTOmatic
EXIT? Push ENTER to quit Setup, push SELECT to return to the top menu