Rice Lake Magnamount - Manual (Page 5)

15
50K—5/8"—11 x 1-1/4"
100K—1-3/4"—10 x 1-3/4"
200K—1"—8 x 2-1/2"
1/2"—13 x 2"
Top Mount Plate
Retaining Plate
Tension Pin
Top Fabreeka Pad
Bottom Fabreeka
Bottom Plate
Flexure Plate
Top Mount Washer
Top Mount Bolt
2.2 Assembling the Retaining Plate
1. Install tension pins 1/4" x 3/4" in retaining plates and bottom plates. Leave
1/4" out of plates.
2. Place the bottom plate on top of the flexure plate (see graphic below).
3. Position the top mounting plate under the flexure plate aligned with the
bottom plate.
4. Screw the top mounting plate to the bottom plate using the top mounting
plate bolts, lockwashers, and washers.
5. Torque the top mounting plate bolts to spec ( see torque value table, page 4).
Note:
The top mounting plate is on the bottom of this assembly and on top of
the load cell.
6. Place the bottom fabreeka pad on the bottom plate.
7. Place the top fabreeka pad on the bottom Fabreeka ® pad.
8. Place the retaining plate on top of the top Fabreeka pad.
Retaining Plate Assembly
3
Fabreeka ® is a registered trademark of Fabreeka International Inc.