Rice Lake GoDEX G500 Direct Thermal/Thermal Transfer Label Printer - Manual (Page 41)

6 Maintenance And Adjustment
G500 S
er
ies
Adjusting The Print Line
When the print line is incorrectly set, the print quality on one side of the medium may suffer.
In such a case, the print line must be adjusted so it is positioned parallel to the paper feed roller.
 Adjustment Methods
1. To move the print head in direction A as indicated by
the blue arrow, turn the adjustment wheel
anticlockwise (see arrow 1).
2. To move the print head in direction B as indicated by
the blue arrow, turn the adjustment wheel clockwise
(see arrow 2).
Adjusting The Cutter
While using the cutter, paper jams may occur. Please follow the below steps to clean the paper jam.
A socket head screw for adjusting the cutter is located on the bottom of cutter module, as shown in below illustration.
 Cleaning Steps
1. Switch off the printer.
2. Use a Philips screwdriver to turn the socket head screw and release the knife.
3. When you have cleared the paper jam, switch on the printer again. The cutter will automatically reset.
6-3
Maintenance and Adjustment
037
6-4
Turn the adjustment wheel
Direction-A
Direction-B
PRINT HEAD
ADJUSTMENT WHEEL

Labels should be at least 30 mm high to ensure correct functioning of the cutter. NOTICE
SOCKET HEAD SCREW
1
2