Rice Lake Datalogic QuickScan QD2100 Linear Imager Hand-held Scanner - Manual (Page 279)

Product Reference Guide 271
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of Table 37 .
The settings in this table are as applied to a standard RS-232 interface. See Table 38 for
a listing of default exceptions to this list as appled to other interface types. Page references
are also provided for feature descriptions and programming barcodes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 37. Standard Defaults
Parameter Default Your Setting Page Number
General Features
Double Read Timeout 0.4 Second 17
Label Gone Timeout 160 ms 19
Power On Alert 4 Beeps 21
Good Read: When to Indicate After Decode 22
Good Read Beep Type Mono 23
Good Read Beep Frequency Medium 24
Good Read Beep Length 80 ms 24
Good Read Beep Volume High 26
Good Read LED Duration
LED on until
next trigger pull
27
Scan Mode Trigger Single 29
Stand Mode Triggered Timeout 0.5 Seconds 31
Scanning Active Time 5 Seconds 33
Flash On Time 1 Second 35
Flash Off Time 600 ms 37
Stand Mode Sensitivity Medium 39
Green Spot Duration 300 ms 40