Rice Lake Datalogic PowerScan RF 8000 Series Laser Scanner - Manual (Page 42)

POWERSCAN ® D8330/M8300
34
Read the BC-8060 restore default code:
5.
Restore BC-8060 Default
Ì$+RX0$-qÎ
Read the desired Enable Network code.
Enable RS-485 Master
6.
Ì$+RZ2$-ÇÎ
Enable RS-485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded for free from the web site:
www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed either through the Datalogic Aladdin™ configuration
software running on the PC or by reading the barcode selections in the Network
section of this manual starting on page 64. If using configuration barcodes, it is
advised to completely configure the cradles before reconfiguring the PowerScan
®
M8300 reader (see below).
NOTE
After completing the BC-8060 cradle configuration and
connections in the network, you must reconfigure the
PowerScan ® M8300 reader using the STAR-System™ procedure
in par. 4.6.