Rice Lake 920i Single Kiosk Truck In/Out - Manual (Page 5)

Introduction 1
1.0 Introduction
This 920i
®
Single Kiosk Truck In/Out program (PN SZ99999) allows trucks to weigh in and out (saves inbound
weight after weighing out and has value swapping) and stores the transaction after each weigh out with Truck ID,
Gross, Tare, Net. Transactions may be printed or cleared at any time through the setup menu. An HID scanner and
EU-T432 kiosk printer are optional peripherals.
This program is for use on a single direction truck platform with a single kiosk. System can control a Stop/Go light.
After a successful download the 920i needs to be power cycled.
2.0 Operation
System displays the
Weigh In
,
Weigh Out, Truck Regs, Setup Menu
softkeys when it powers up or when it exits the
configuration or setup menus.
2.1 Weigh In
1. Press the
Weigh In
softkey.
2. The 920i prompts
Enter ID Inbound
. Enter the truck ID or scan an HID card (must not be weighed in yet)
3. Press the
enter
key.
4. System prints a Weigh In Ticket and displays
Weigh In Complete – Exit Scale
.
2.2 Weigh Out
1. Press the
Weigh Out
softkey.
2. The 920i prompts
Enter ID Outbound
. Enter the truck ID or scan an HID card (must have a stored tare from
a previous inbound weighment).
3. Press
enter
key.
4. System does the following:
ID FOUND
• Prints a Weigh Out Ticket
• Displays
Weigh Out Complete – Exit Scale
.
• Stores a Transaction.
• Removes the inbound weighment if Store Tares is NO.
When memory is full, the system automatically deletes the oldest 25% of data.
ID NOT FOUND
• System displays ID Not Found.
2.3 Truck Register
Pressing the
Truck Regs
softkey shows all the stored inbound tare weights and IDs and time/dates. Use softkeys to
page up, page down, delete an individual Inbound Tare weight, delete all Inbound Tare weights, or exit back to the
starting keys.
Note
Note