Rice Lake 920i Dual Kiosk Truck In/Out - Manual (Page 6)

2 Dual Kiosk Truck In/Out Software Operation Manual
2.2 Processing a Truck with Loop Detectors
1. System displays Waiting to Zero on both the Inbound and Outbound kiosk while showing RED on the
traffic signal and Stop/Go Remotes.
2. Driver pulls the truck onto the approach and parks on one of the loops.
3. System zeros the scale, displays
Enter Scale on both the Inbound and Outbound kiosk, and shows
GREEN on the traffic signal and Stop/Go Remotes.
4. Driver pulls the truck fully onto the scale and stops his truck next to a kiosk. If the driver does not exceed
the Threshold Weight before the Loop Enter Scale Time the system goes back to STEP 1.
5. System displays Enter Truck Id or Scan Tag once the scale weight exceeds the Threshold Weight and the
Drive On Delay has timed out. Both traffic signals will change to RED . Both photo eye inputs must also
be activated showing that the truck is clear of the photo eyes. This feature may be disabled in the Setup
Menu. If blocked, the prompt goes away and displays
Photo Eye Blocked .
6. Driver enters his Id with the numeric keypad or scans his HID RF tag.
7. System queries the Truck database table with the entered ID/or scanned RF Tag and performs one of the
following actions:
ID FOUND
• Captures the stable weight.
• Recalls the inbound stored weight and calculates the net weight.
• Prints an Outbound ticket on the kiosk that initiated the process.
• Adds a new record to the Trans database table.
When memory is full, the system automatically deletes the oldest 25% of data.
• Displays – “Outbound Complete – Exit Scale”.
• Increments the Ticket Number.
• Deletes the inbound truck from the Truck database if Stored Tare is disabled. If enabled system updates
the inbound truck tare with the Inbound stored weight.
• Reprint option available until the truck exits the scale.
ID NOT FOUND
• Captures the stable weight.
• Adds a new record to the Truck database table.
• Prints an Inbound Ticket on the kiosk that initiated the process.
• Displays Inbound Complete – Exit Scale .
• Reprint option available until the truck exits the scale.
8. Both traffic signals on the scale are changed to GREEN until the weight drops below Threshold Weight.
9. Both traffic signals on the scale are changed to RED .
10. System delays for the Loop Exit Delay (ignoring the loop detectors) before it starts to monitor both the
loop detectors.
Note