Drawer kick-out connector, 1 specifications of drawer kick-out connector, 2 connector's pin configuration – Citizen Systems iDP3420 User Manual
Page 54: 3 drive circuit
iDP3420/3421/3423 User’s Manual
38
CITIZEN
11. DRAWER KICK-OUT CONNECTOR
11.1
Specifications of Drawer Kick-Out Connector
(1) Drawer kick-out drive signal
Parallel
----- Can be learned at the no. 34 pin of the interface connector
Serial
----- Provided with a command to learn the status in the Star and ESC/POS modes.
(2) Electrical characteristics
1) Drive voltage: 24 V DC
2) Drive current: 0.8 A at maximum (Within 510 ms)
3) Switch signal: Signal level
"L" = 0 to 0.5 V
"H" = 3 to 5 V
11.2
Connector's Pin Configuration
No.
Signal
Function
1
FG
Frame Ground
2
DRAWER 1
Drawer 1 drive signal
3
DRSW
Drawer switch input
4
VDR
Drawer drive power
5
DRAWER 2
Drawer 2 drive signal
6
GND
Common ground on the circuit
Connector used
: TM5RJ3-66 (HIROSE)
Applicable connector
: TM3P-66P (HIROSE) or equivalent
CAUTION
:
•
No output is made while printing.
•
The drawers 1 and 2 cannot be driven simultaneously.
•
A solenoid used for the drawer should be of 36
Ω
or more.
An output current should be
kept below 0.8 A. Use beyond this limit cannot be assured.
•
This connector cannot be connected to a telephone line.
Do not connect other than
the solenoid.
11.3
Drive Circuit