Mercedes-Benz R-Class 2007 Owners Manual - Manual (Page 265)

264
Controls in detail
Panorama roof with power tilt/sliding panel*
Synchronizing the panorama roof with
power tilt/sliding panel
The tilt/sliding panel and its roller
sunblinds must be synchronized
ț after the battery has been
disconnected or discharged
ț after a malfunction
ț if the tilt/sliding panel does not open
smoothly
̈ Switch off the ignition ( ୴ page 40) and
remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
̈ Switch off the ignition ( ୴ page 41).
̈ Open the driver’s door (this puts
the starter switch in position 0,
same as with the SmartKey re-
moved from the starter switch). The
driver’s door then can be closed
again.
̈ Remove the fuse for the tilt/sliding
panel from the fuse box (
୴ page 521).
̈ Reinsert the fuse in the fuse box.
̈ Switch on the ignition ( ୴ page 39).
̈ Push and hold the roof panel switch in
direction of arrow
2 ( ୴ page 263)
until the roller sunblinds are fully
closed.
̈ Keep holding the roof panel switch in
direction of arrow
2 ( ୴ page 263) for
approximately 1 second.
̈ Pull and hold the roof panel switch in
direction of arrow
1 ( ୴ page 263)
until the roller sunblinds are fully
opened.
̈ Keep holding the roof panel switch in
direction of arrow
1 ( ୴ page 263) for
approximately 1 second.
! Do not attempt to open or close the
tilt/sliding panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding panel
could otherwise lock-up in the open position.
If the tilt/sliding panel cannot be closed or
synchronized, see an authorized Mercedes-Benz
Light Truck Center or call Roadside Assistance
(
୴ page 333).
i For information on which fuse box contains
the fuse for the power tilt/sliding panel, see the
fuse chart provided with the vehicle tool kit
(
୴ page 473).