Mercedes-Benz CLK-Class 2009 Owners Manual - Manual (Page 96)

Memory function
94
i At low ambient temperatures, the exterior
rear view mirrors will be heated
automatically.
Auto-dimming rear view mirrors
The exterior rear view mirror on the driver’s
side and the interior rear view mirror will
respond automatically to glare when the
ignition is switched on and incoming light
from headlamps falls on the sensor in the
interior rear view mirror.
The rear view mirrors will not react if the
automatic transmission is set to reverse gear
R or the interior lighting is switched on.
G Warning!
The auto dimming function does not react
if incoming light is not aimed directly at
sensors in the interior rear view mirror.
The interior rear view mirror and the
exterior rear view mirror on the driver’s side
do not react, for example, if the rear window
sunshade is in raised position.
Light hitting the mirror(s) at certain angles
(incident light) could blind you. As a result,
you may not be able to observe traffic
conditions and could cause an accident.
Memory function
Notes
With the memory function you can store up
to three different configurations per front
seat.
Each memory position button on the driver’s
side can store all of the following settings:
R Seat position
R Multicontour seat: previously saved setting
R Steering wheel position
R Exterior rear view mirrors’ position
G Warning!
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
Each stored position on the passenger side
includes the setting of the seat position.
1 Memory button
2 Memory position switch
X Switch on the ignition.
or
X Open the respective door and insert the
SmartKey in the starter switch.
Storing positions into memory
X Adjust the seats.
X On the driver’s side, additionally adjust the
steering wheel and exterior rear view
mirrors to the desired positions.
X Turn memory position switch 2 to the
desired memory position.
X Press memory button 1 .
X Release memory button 1 and press
memory position switch 2 within
3 seconds.
All settings are stored to the selected
position.
Controls in detail