Mercedes-Benz CLK-Class 2009 Owners Manual - Manual (Page 107)

Power windows
105
point and released, the automatic reversal
will not operate.
Synchronizing power windows
The windows must be synchronized after the
battery has been disconnected or if the
windows cannot be fully closed (express
operation).
Each window must be synchronized
separately.
X Close all doors.
X Switch on the ignition.
X Pull and hold switch 1 , 2 , 3 or 4
( Y page 104) until the respective window is
closed.
X Hold the respective switch for
approximately 1 second.
The window is synchronized.
Summer opening feature
G Warning!
Never operate the windows and/or the tilt/
sliding sunroof (CLK coupe), or soft top
(CLK cabriolet), if there is the possibility of
anyone being harmed by the opening or
closing procedure.
In the event that the procedure causes
potential danger, the procedure can be
immediately halted by releasing the button
on the SmartKey. To reverse direction of
movement, press k for opening or
j for closing.
If the weather is warm, you can ventilate the
vehicle before driving off by simultaneously:
R opening the windows
R opening the tilt/sliding sunroof (CLK
coupe)
R opening the soft top (CLK cabriolet)
R switching on the seat ventilation for the
driver’s seat
The summer opening feature can only be
activated via the remote control of the
SmartKey. The SmartKey must be in close
proximity to the driver’s outside door handle.
X Aim transmitter eye of the SmartKey at the
driver’s outside door handle.
X Press and hold button k on the
SmartKey after unlocking the vehicle until
the windows and the tilt/sliding sunroof
(CLK coupe) have reached the desired
position or the soft top (CLK cabriolet) is
fully open.
The vehicle unlocks.
The windows and tilt/sliding sunroof (CLK
coupe) or soft top (CLK cabriolet) begin to
open after approximately 1 second.
CLK cabriolet: The message Top In
Operation appears in the multifunction
display.
X CLK cabriolet: Make sure the soft top is
fully opened.
X Release button k on the SmartKey to
interrupt the opening procedure.
Controls in detail
Z