Mercedes-Benz CLK-Class 2009 Owners Manual - Manual (Page 337)

Replacing bulbs
335
Front turn signal lamp bulb
X Turn bulb socket 3 with the bulb
counterclockwise and remove it.
X Gently press onto the bulb and turn it
counterclockwise out of bulb socket
3 .
X Gently press the new bulb into bulb socket
3 and turn it clockwise until it engages.
X Place bulb socket 3 back into the housing
and turn it clockwise until it engages.
Parking and standing lamp bulb
X Turn housing cover 2 counterclockwise
and remove it.
X Pull out bulb socket 6 with the bulb.
X Pull the bulb out of bulb socket 6 .
X Gently press the new bulb into bulb socket
6 .
X Reinstall bulb socket 6 .
X Align housing cover 2 and turn it
clockwise until it engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
M .
X Open the trunk.
Tail lamp unit
X Swing the trim panel covering the
corresponding rear lights to the side.
1 Connector
2 Tab
X Disconnect electrical connector 1 .
X Pull tab 2 in the direction of the arrow.
X Remove the bulb carrier.
Bulb carrier
3
Brake lamp
4 Backup lamp
5 Rear fog lamp (driver’s side)/tail lamp
6 Tail lamp, parking and standing lamp, side
marker lamp
7 Turn signal lamp
X Depending on which bulb needs to be
replaced, gently press onto the respective
bulb and turn it counterclockwise out of its
bulb socket.
X Gently press the new bulb into its bulb
socket and turn clockwise until it engages.
Practical hints
Z