Mercedes-Benz C-Class 2009 Owners Manual - Manual (Page 360)

Replacing bulbs
358
Front turn signal lamp bulb
1 Mark
2 Handle
3 Bulb socket
X Turn bulb socket 3 with handle 2
counterclockwise and remove it.
X Pull bulb out of bulb socket 3 .
X Gently press the new bulb into bulb socket
3 until the bulb engages.
X Place bulb socket 3 back into the housing.
Handle 2 must be in a horizontal line and
mark 1 must be on the upper part (driver’s
side headlamp) or lower part (passenger-
side headlamp).
X Turn bulb socket 3 clockwise until it
engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
M .
X Open the trunk.
Tail lamp unit
X Driver’s side: Lift up the bottom and pull out
the trim panel covering the driver side rear
light.
X Passenger side: Open the fuse box in the
trunk (
Y page 373).
1 Tabs
2 Connector
X Disconnect electrical connector 2 .
X Pull tabs 1 in direction of arrows.
X Remove the bulb carrier.
Practical hints