Mercedes-Benz S-Class 2014 Owners Manual - Manual (Page 233)

R if the camera lenses are dirty or covered
R if the vehicle components in which the
cameras are installed are damaged. In this
event, have the camera position and setting
checked at a qualified specialist workshop.
Do not use the 360° camera in this case. You
can otherwise injure others or cause damage
to objects or the vehicle.
Guide lines are always shown at road level.
The cameras in the front and in the rear area
are each protected by a flap. These flaps are
opened when the 360° camera is activated.
Observe the notes on cleaning
(
Y
page 358). For technical reasons, the flaps
may remain open briefly after the 360°
camera has been deactivated.
Activation conditions
The 360° camera image can be displayed if:
R COMAND is switched on (see the separate
operating instructions)
R the 360° Camera 360° Camera function is activated
i If the 360° camera is activated at speeds
above 19 mph (30 km/h) a warning
message appears.
The warning message disappears if:
R the vehicle's speed falls below 19 mph
(30 km/h). The 360° camera is then
activated.
R the message is confirmed with the
a button.
Activating the 360° camera using the
function button
X
Press button :.
Depending on whether position D or R is
engaged, the following is shown:
R full screen display with the image from
the front camera
R full screen display with the image from
the rear camera
i You can also switch to the split-screen
view from the full-screen view.
Activating the 360° camera with
COMAND
X To select the 360° 360° Camera Camera from the vehicle
carousel: turn and press the controller.
Depending on whether position D or R is
engaged, the following is shown:
R a split screen with top view and the
image from the front camera or
R a split screen with top view and the
image from the rear view camera
Further information on the COMAND
controller can be found in the separate
operating instructions.
Activating the 360° camera using
reverse gear
The 360° camera images can be
automatically displayed by engaging reverse
gear.
Driving systems
231
Driving
and
parking
Z