Opening and closing, Side windows – Mercedes-Benz S-Class 2014 Owners Manual User Manual
Page 103
On vehicles with a panorama roof with power
tilt/sliding panel, you can then close the
roller sunblinds.
i
Notes on the automatic reversing feature
for:
R
the side window (
Y
page 99)
R
the panorama roof with power tilt/
sliding panel (
Y
page 103)
Using the SmartKey
X
Press and hold the & button until the
side windows and the panorama roof with
power tilt/sliding panel are fully closed.
X
Make sure that all the side windows and the
panorama roof with power tilt/sliding
panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
X
Press and hold the & button again until
the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
X
To interrupt convenience closing:
release the & button.
Using KEYLESS-GO
The SmartKey must be outside the vehicle. All
the doors must be closed.
X
Touch recessed sensor surface : on the
door handle until the side windows and the
panorama roof with power tilt/sliding
panel are fully closed.
i
Make sure you only touch recessed
sensor surface :.
X
Make sure that all the side windows and the
panorama roof with power tilt/sliding
panel are closed.
X
Touch recessed sensor surface : on the
door handle again until the roller sunblinds
of the panorama roof with power tilt/
sliding panel close.
X
To interrupt convenience closing:
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
X
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Pull the corresponding switch on the door
control panel until the side window is
completely closed (
Y
page 99).
X
Hold the switch for an additional second.
If the side window opens again slightly:
X
Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed (
Y
page 99).
X
Hold the switch for an additional second.
X
If the respective side window remains
closed after the button is released, then it
has been set correctly. If this is not the
case, repeat the steps above again.
Side windows
101
Opening
and
closing
Z