Tec hni ca ldata, Service products and filling capacities – Mercedes-Benz SLK-Class 2015 Owners Manual User Manual
Page 349
VIN
X
Slide the front-passenger seat to its front
most position.
X
Fold trim : upwards.
VIN ; can be seen.
The VIN can also be found in the following
locations:
R
on the vehicle identification plate
(
Y
page 346)
R
on the lower edge of the windshield
(
Y
page 347)
Engine number
:
Emission control information plate,
including the certification of both federal
and Californian emissions standards
;
Engine number (stamped into the crank-
case)
=
VIN (on the lower edge of the windshield)
Service products and filling capaci-
ties
Important safety notes
G
WARNING
Service products may be poisonous and haz-
ardous to health. There is a risk of injury.
Comply with instructions on the use, storage
and disposal of service products on the labels
of the respective original containers. Always
store service products sealed in their original
containers. Always keep service products out
of the reach of children.
H
Environmental note
Dispose of service products in an environ-
mentally responsible manner.
Service products include the following:
R
Fuels
R
Lubricants (e.g. engine oil, transmission oil)
R
Coolant
R
Brake fluid
R
Windshield washer fluid
R
Climate control system refrigerant
Comply with all valid regulations with respect
to handling, storing, and disposing of service
fluids.
Components and service products must be
matched. You should therefore only use prod-
ucts that have been tested and approved by
Mercedes-Benz.
Information about tested and approved prod-
ucts can be obtained from an authorized
Mercedes-Benz Center or on the Internet at
http://bevo.mercedes-benz.com.
You can recognize service products approved
by Mercedes-Benz by the following inscrip-
tion on the containers:
R
MB-Freigabe (e.g. MB-Freigabe 229.51)
R
MB Approval (e.g. MB Approval 229.51)
Other designations or recommendations indi-
cate a level of quality or a specification in
accordance with an MB Sheet Number (e.g.
Service products and filling capacities
347
Tec
hni
ca
ldata
Z