Losi LOSB0105BD - Manual (Page 4)

Supplied and Required Equipment
Four (4) AA batteries
NiMH battery charger with automatic “peak detection” or
LiPo-compatible charger recommended.
Using Your Charger:
If you do not yet have a charger, a peak detecting charger will
provide the performance required and take care of your expensive
batteries.
A popular choice for a charger would be a peak detection charger
that can be plugged into a household AC wall socket. The peak
detection portion of the charger monitors the battery charging and
will automatically shut off upon full charge.
Other peak detection chargers require a 12V power source to
charge your batteries. You would need to use or purchase a
hobby grade 12V power supply before charging.
If you are going to be using a charger other than a peak detection
charger it is important to have your battery fully discharged prior
to recharging. Many of these have a timer that allows you to set
the amount of charge time. If the battery was not fully discharged
from prior use, you can potentially overcharge your battery pack.
If you are using a LiPo battery be sure to consult the
manufacturer’s suggestions for an appropriate LiPo-compatible
charger. Chargers designed for NiMH cells only should never be
used to charge your LiPo batteries and could result in serious
injury.
Do not charge any battery unattended, and monitor for heat build
up. If the battery pack is more than warm to the touch immediately
discontinue charging.
Read all safety precautions supplied by the charger manufacturer,
and also any from the battery manufacturer.
Supplied Tools:
2-Way wrench
Flat Turnbuckle Wrench
Three (3) Hex Wrenches (L shaped) 3/32, 5/64, and 1/16
Bind Plug
Recommended Accessories:
- Hobby grade knife
- CA glue (LOSA7880 or LOSA7881)
- Needle-nose pliers
- Side-cutting pliers
- Double-sided tape (LOSA4004)
- Safety Goggles
- Soldering iron
Required Equipment:
A Six (6) cell NiMH or 2S LiPo battery pack. 1
2
3
Vehicle Battery
(6-Cell 7.2V “Stick Pack”)
LOSB9903
MultiPro™ Intelligent Balance Charger (LOSB9606)
AC Adapter (LOSB9604) required for AC operation
4