Kontron COMe-cDC2 - Manual (Page 27)

COMe-cDC2 / Features and Interfaces
4 Features and Interfaces
4.1 Onboard SSD
The COMe-cDC2 features an onboard Greenliant PATA NAND flash drive with capacities of 512MB to 8GB SLC (PATA). Due to
performance and longevity reasons standard variants with onboard flash use SLC type only. The following PATA NANDrives
are available:
Basic features of the PATA NANDrives
» 16-bit ATA/IDE Bus Interface with PIO Mode-6, Multi-Word DMA Mode-4 and Ultra DMA Mode-4
» RoHS compliant NAND flash type
» Hardware error detection and correction ECC
» Advanced wear leveling
» Bad block management
SLC NANDrive™
Flash Part No. GLS85LP0512P-S-I-LBTE GLS85LP1002P-S-I-FTE GLS85LP1004P-S-I-FTE GLS85LP1008P-S-I-FTE
Temperature Range -40°C to +85°C -40°C to +85°C -40°C to +85°C -40°C to +85°C
Flash Size 512MB 2GB 4GB 8GB
NAND Type SLC NAND SLC NAND SLC NAND SLC NAND
Sustained Read Speed 25 MB/s 28 MB/s 50 MB/s 50 MB/s
Sustained Write Speed 6 MB/s 11 MB/s 20 MB/s 39 MB/s
Total Bytes 456,744,960 2,000,388,096 4,068,384,768 8,136,769,536
Max LBA 892,080 3,907,008 7,946,064 15,892,128
Cylinders/Heads/Sectors 885/16/63 3,876/16/63 7,883/16/63 15,766/16/63
Active Mode Power 200mW 200mW 265mW 365mW
Program/Erase Cycles per Block 100k 100k 100k 100k
(Data based on GLS85LPxxxxP Datasheet Rev. 02.000 from 06-2012)
The NAND Flash types listed above are available on COMe-mSP1 hardware revision CE4.7.0
and COMe-cDC2 hardware revision CE 2.4.1 or newer. Please contact your local sales or
support for Flash specifications of SST Flash used on older revisions
27