Kontron AM5030 uEFI - Manual (Page 64)

The uEFI Shell AM5030 uEFI BIOS
Page 58 ID 1037-1209, Rev. 1.0
P R E L I M I N A R Y
SETTINGS: fru []: Displays FRU data
Options:
Fru device ID:
Numeric FRU device ID. 0 if FRU is omitted. FRU
device 0 is the baseboard’s own FRU.
ipmb: Displays IPMB bus settings
ipmb redundant: Switch IPMB bus to redundant mode
ipmb single: Switch IPMB bus to single mode
Irq : Display/Set the IRQ number of the KCS interface
Options:
0:
KCS uses no IRQ
10: KCS uses IRQ 10
11: KCS uses IRQ 11
The board must be reset for the settings to apply.
Mode : Display/Set the IPMI controller operating mode
Options:
bmc:
IPMI controller operates in BMC mode
smc: IPMI controller operates in SMC mode
Net: Set Serial-over-LAN parameters
Sel: Display system event log
Note: The AM5030 does not have a system event log.
Sensor list|read: Show board sensor data
Options:
list:
Display an overview of all available board sensors
read: Display specific sensor data
Raw [ <...>]: Execute raw IPMI command
Syntax:
raw [NetFn] [LUN] [COMMAND] ...
Rawsendmesage [ <...>]: Bridge raw IPMI command
Syntax:
raw [rsSA] [Channel] [NetFnm] [Lun] [function]...
Info: Display IPMI firmware information
kipmi