Kontron AM5030 uEFI - Manual (Page 63)

AM5030 uEFI BIOS The uEFI Shell
ID 1037-1209, Rev. 1.0 Page 57
P R E L I M I N A R Y
kipmi
FUNCTION: Read or configure available Board Management Controller parameters
SYNTAX: kipmi [-?|-b|parameters]
where:
-? show online help
-b display output page by page
parameters fru -- display fru data
ipmb -- ipmb bus settings: ipmb [redundant/single]
irq -- irq [number]: get/set KCS IRQ
mode -- set ipmi controller mode: mode [bmc/smc]
net -- display and change mode SOL network settings
sel -- handle system event log
raw -- execute raw ipmi command
rawsendmessage -- execute rawsendmessage ipmi
command
info -- show information about the device and firmware
DESCRIPTION: The kipmi command can read event logs or can set the Board
Management Controller IRQ configuration. This shell application can
also be used to set up raw command to the Board Management
Controller.
USAGE: Read or configure available Board Management Controller parameters
COMMAND / RESPONSE:
Display fru
kipmi fru -b
Clear all sel entries
kipmi sel clear
Display sel entry number 3 in hex
kipmi sel raw 0x03
Execute raw command. Ex: Get selftest results
kipmi raw 0x06 0x00 0x04
Change IRQ
kipmi irq 10
Show IRQ configuration
kipmi irq