Kontron AM5030 uEFI - Manual (Page 55)

AM5030 uEFI BIOS The uEFI Shell
ID 1037-1209, Rev. 1.0 Page 49
P R E L I M I N A R Y
kboardconfig
FUNCTION: Configure the non-volatile board settings
SYNTAX: kboardconfig
kboardconfig [-?||]
where:
? Show online help
Specify device from list
Select configuration type
DESCRIPTION: The kboardconfig command enables the PXE feature or sets the front/
rear I/O configuration of the dedicated device.
USAGE: Show all possible configurations
COMMAND / RESPONSE:
Shell> kboardconfig
Control nonvolatile board settings
Example: kboardconfig
hyperThreading: Enable Hyper Threading technology (disabled
[enabled])
pxe: config ([disabled] all gbe_a gbe_b amc_a amc_b xaui_a xaui_b)
sataMode: SATA controller config (disabled [ide] ahci raid)
amcport_2: SATA Port config ([e-keying] forced_on)
amcport_3: SATA Port config ([e-keying] forced_on)
amcport_12: SATA Port config ([e-keying] forced_on)
amcport_13: SATA Port config ([e-keying] forced_on)
storageOrom: Launch Storage PCI OpROM (disabled [enabled])
vga: VGA Port Configuration (disabled [enabled])
bootvideo: Select preferred boot video device (amc [onboard])
wr_prot_eeprom: System EEprom write protection ([disabled]
enabled)
wr_prot_sata: Onboard Sata flash write protection ([disabled]
enabled)
wr_prot_spi: EFI spi flash write protection ([disabled] enabled)
Show allowed settings e.g. for “bootvideo”:
Shell> kboardconfig bootvideo
bootvideo: Select preferred boot video device
bootvideo == onboard
Allowed options: amc, onboard
SETTINGS hyperThreading: Enable/Disable Hyper-Threading Technology