Kontron AM5030 IPMI - Manual (Page 40)

IPMI Firmware User Guide AM5030
Page 40 ID: 1042-7364, Rev. 1.0
10.3 Basic Setup from EFI-Shell
With the ‘kipmi net’ command from EFI-Shell some basic settings like IP address, sub-net
mask and gateway address can be setup for all of the four Ethernet channels.
10.4 Setup by “ipmitool” or Raw IPMI Commands
The open tool “ipmitool” offers commands for the setup of the four Ethernet channels. All pos-
sible options are shown by issuing:
If “ipmitool” is not usable, the LAN parameters can be set by using the raw IPMI commands
which are defined for this.
To show the current LAN parameters for a channel, “ipmitool” offers the command:
10.5 Setup of User and Password
The open tool “ipmitool” offers commands for the listing and manipulation of user accounts for
channels 1 through 4. An overview can be obtained by issuing:
The predefined users for a channel can be listed by the command:
The AM5030 has for every channel these predefinitions in non-volatile memory:
Please note that admin’s password is preset with ‘admin’.
Changed users and passwords stay valid after payload power off.
The user (ID number, from above) must be activated by:
ipmitool lan set
ipmitool lan print
ipmitool user
ipmitool user list
ID Name Callin Link Auth IPMI Msg Channel Priv Limit
1 false true true USER
2 admin false true true ADMINISTRATOR
ipmitool user enable