beautypg.com

2 set control state (firmware hub, boot order), Set control state, Am5030 ipmi firmware user guide – Kontron AM5030 IPMI User Manual

Page 23

background image

AM5030

IPMI Firmware User Guide

ID: 1042-7364, Rev. 1.0

Page 23

3.2

Set Control State (Firmware Hub, Boot Order)

Table 6:

Set Control State

COMMAND

LUN

NetFn

CMD

Set Control State (Firmware Hub, Boot Order)

00h

OEM = 3Eh

20h

REQUEST DATA

Byte

Data Field

1

Control ID:
00h = Firmware Hub (BIOS Flash) selection
9Dh = BIOS Boot Order Configuration

2

Control State for BIOS Flash selection:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = BIOS Flash selection is not inverted
01h = BIOS Flash selection is logically inverted
Please note that this selection will be automatically toggled by the IPMI controller during a
failing boot process. Other payload sided settings may additionally modify this selection.

Control State for BIOS Boot Order Configuration:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = No override, boot as usual
01h = Next boot device is: Floppy
02h = Next boot device is: HDD
03h = Next boot device is: CD
04h = Next boot device is: Network
05h = Next boot device is: USB Floppy
06h = Next boot device is: USB HDD
07h = Next boot device is: USB CDROM

RESPONSE DATA

Byte

Data Field

1

Completion Code