Kontron AM5030 IPMI - Manual (Page 22)

IPMI Firmware User Guide AM5030
Page 22 ID: 1042-7364, Rev. 1.0
3. OEM Commands and Command Extensions
3.1 Get Device ID Command with OEM Extensions
The IPMI specification defines four optional bytes in the response to 'Get Device ID'. The re-
sponse bytes [13:16] hold the 'Auxiliary Firmware Revision Information'.
Table 5: Get Device ID Command with OEM Extensions
COMMAND LUN NetFn CMD
Get Device ID command with OEM extensions 00h App = 06h 01h
REQUEST DATA
Byte Data Field
- -
RESPONSE DATA
Byte Data Field
1 Completion Code
2:12 Regular Get Device ID Command response fields
13 Release number of the management controller firmware:
10h for R10,
11h for R11,
…
14 Module Geographical Address (site number):
1 … 8 = Module in AMC bay A1, A2, A3, A4, B1, B2, B3, B4
or in µTCA slot 1 … 8 with bus addresses
72h, 74h, 76h, 78h, 7ah, 7ch, 7eh, 80h
9 …12 = Module in µTCA slot 9 … 12 = Bay C1, C2, C3, C4
with bus addresses 82h, 84h, 86h,88h
0, > 12 = Module position is not in range. The IPMB-L bus is
switched off.
15 Reserved
16 Reserved