Kontron AM5030 IPMI - Manual (Page 28)

IPMI Firmware User Guide AM5030
Page 28 ID: 1042-7364, Rev. 1.0
1Bh /
A1:Pwr Good Power supply (08h) /
OEM (77h) 0000h / 0000h /
0887h States of all power lines N
1Ch /
A1:Pwr Good Evt Power supply (08h) /
OEM (77h) 0000h / 0887h /
0887h Power fail events for all
power lines Y
1Dh /
A1:CPU status Processor (07h) /
Sensor-specific (6Fh) 0463h / 0400h /
04E3h CPU thermal alarm sensor N
1Eh /
A1:FWH0 Boot Err Boot Error (1Eh) /
Sensor-specific (6Fh) 0008h / 0008h /
0008h Firmware Hub 0 boot error Y
1Fh /
A1:FWH1 Boot Err Boot Error (1Eh) /
Sensor-specific (6Fh) 0008h / 0008h /
0008h Firmware Hub 1 boot error Y
20h /
A1:POST Value OEM Post Value (C6h) /
OEM (78h) 0000h / 0000h /
00FFh POST Value (from host I/O
port 80h) N
21h /
A1:Lan AMC0 Link LAN (27h) /
Sensor-specific (6Fh) 0000h / 0000h /
0003h LAN link status –
AMC port 0 N
22h /
A1:Lan AMC1 Link LAN (27h) /
Sensor-specific (6Fh) 0000h / 0000h /
0003h LAN link status –
AMC port 1 N
24h /
A1:Lan Front0 Lk LAN (27h) /
Sensor-specific (6Fh) 0000h / 0000h /
0003h LAN link status –
Front port 0 N
25h /
A1:Lan Front1 Lk LAN (27h) /
Sensor-specific (6Fh) 0000h / 0000h /
0003h LAN link status –
Front port 1 N
26h /
A1:Temp VRegHot Temperature (01h) /
Threshold (01h) 0280h / 3280h /
1818h
See description below:
Y
Virtual temperature sensor based on VCORE_HOT and VCORE_FAN, processor core
voltage regulator’s over-temperature signals.
Sensor readings:
0°C: no over-temperature
110°C: VCORE_HOT active
100°C: VCORE_FAN active
27h /
A1:Temp ProcHot Temperature (01h) /
Threshold (01h) 0280h / 3280h /
1818h
See description below:
Y
Virtual temperature sensor based on PROCHOT and THERMTRIP, CPU’s over-
temperature signals.
Sensor readings:
0°C: no over-temperature
125°C: THERMTRIP active
105°C: PROCHOT active
Table 9: Sensor List
Sensor Number
Name
Sensor Type (Code) /
Event/Reading Type
(Code)
Ass. Mask /
Deass. Mask /
Reading Mask
Description
Health
LED Red
on Error