Kontron AM5010 IPMI - Manual (Page 19)

AM5010 IPMI Firmware User Guide
ID 1022-2948, Rev. 1.0 © 2008 Kontron AG Page 19
6.2.2.3 Set Control State (Firmware Hub, Boot Order)
LUN NetFn CMD
Set Control State (Firmware Hub, Boot Order) 00h OEM = 3Eh 20h
Byte Data Field
1 Control ID
00h: Firmware Hub (BIOS Flash) selection
9Dh: BIOS Boot Order Configuration
Request data
2 Control State for BIOS Flash selection:
(These settings are stored in EEPROM and applied (to
logic) each time the IPMI controller detects power-on)
00h = BIOS Flash selection is not inverted
01h = BIOS Flash selection is logically inverted
Please note that this selection will be automatically toggled
by the IPMI controller during a failing boot process. Other
payload sided settings may additionally modify this selection.
Control State for BIOS Boot Order Configuration:
(These settings are stored in EEPROM and applied (to
logic) each time the IPMI controller detects power-on)
00h: No override, boot as usual
01h: Next boot device is: Floppy
02h: Next boot device is: HDD
03h: Next boot device is: CD
04h: Next boot device is: Network
05h: Next boot device is: USB Floppy
06h: Next boot device is: USB HDD
07h: Next boot device is: USB CDROM
Response data 1 Completion code