Kontron AM5010 IPMI - Manual (Page 18)

IPMI Firmware User Guide AM5010
Page 18 © 2008 Kontron AG ID 1022-2948, Rev. 1.0
6.2.2.2 Set Firmware Parameters
The command below permits the selection of interrupts to be used during KCS
communication. Please refer to chapter 6.5 of this manual for further details regarding MMC
configuration.
LUN NetFn CMD
Set Firmware Parameters 03h OEM = 3Eh 05h
Byte Data Field
1 Reserved
B4h
2 Reserved
90h
3 Reserved
91h
4 Reserved
8Bh
5 Cmd Flags
[6:2] Reserved
[1] 0b = get only, 1b = set parameters
[0] 0b = do not reset
1b = reset MMC after setting parameters
6 Operating Modes
[7:5] Reserved ( = 111b)
[4] Reserved ( = 1b)
[3:1] Reserved ( = 111b)
[0] Reserved ( = 1b)
Request data
7 IRQ number
FFh or 00h = do not use interrupts
0Ah = use IRQ10
0Bh = use IRQ11
Any other values Reserved.
1 Completion code
2 Cmd Flags
3 Operating Modes
Response data
4 IRQ number