Kontron AT8904 - Manual (Page 61)

AT8904M Hardware Description
Page 3 - 27 AT8904M User Guide
The main building blocks of the AM4310 are:
• XFP Ports
• XAUI to XFI Transceivers
• IPMI
• Power Supply
3.3.1 XFP Ports
The AMC module contains two 10 GbE XFP uplinks at the front panel. XFP modules are not
provided with the AM4310 and have to be obtained separately. The XFP uplink ports are ac-
cording to the SFF Committee, INF-80077i, rev. 4.0, 10 Gigabit Small Form Factor Pluggable
Module (XFP). Modules with -5.0V are not supported. An application note with a list of XFP
modules successfully operated in the AM4310 is available upon request.
The XFP cages have the following pin assignment.
Caution!
Do not look into the laser beam!
The XFP modules are fitted with a class 1 or 1M laser. To avoid possible
exposure to hazardous levels of invisible laser radiation, do not exceed max-
imum ratings.
Warning!
The XFP cages have heatsinks which can dissipate 1.5W with no airflow. If
the XFP module consumes more than 1.5W (up to 3.5W), the user has to
ensure sufficient airflow to cool the XFP module. Otherwise, the modules
may be damaged.
Table 3-23: XFP Connector Pin Assignment
Pin No Signal Description
1 GND Module Ground
2 VEE5 Not connected
3 MOD_DE_SEL Module De-select; When held low, allows module to
respond to 2-wire serial interface
4 INTERRUPT# Not connected
5 TX_DIS Transmitter Disable; Turns off transmitter laser output
6 VCC5 +5V Power Supply
7 GND Module Ground
8 VCC3 +3.3V Power Supply
9 VCC3 +3.3V Power Supply
10 SCL I²C Serial Interface Clock
11 SDA I²C Serial Interface Data Line