Kontron AT8904 - Manual (Page 24)

AT8904M Introduction
Page 1 - 11 AT8904M User Guide
Table 1-3: AM4310 Main Specifications
AM4310 SPECIFICATIONS
Ethernet
Broadcom 8704
10GbE PHY • 4-Lane XAUI Interface (3.125 Gbps)
• XFP Interface
• Loss of signal detection
• Standard compliant 802.3ae
• IEEE 1149.1 (JTAG) boundary scan
Interfaces
XAUI Interface (AMC
Connector) • Fabric Fabric channels 1-5: 2 x GbE (1000BASE-BX)
• Fabric channels 6-15: 1 x GbE (1000BASE-BX)
• channels 4-11: 2 x 10GbE
• Fabric channel 12: XG management interface (MDIO)
Front panel • 2 XFP cages
General
Mechanical • Standard full height/single width AMC compliant to PICMG 3.0
• 73.6 mm x 180.7 mm (2.898“ x 7.114“)
Power Requirements • 65Maximum: 24W175
• Operating Voltage: 3.0 to 3.6V Management, 10 to 14V Payload
Temperature Designed to meet or exceed the following:
• Air Flow: 30 CFM min
• Operating: 0°C to +55°C (32°F to 131°F)
• Non-operating: -40°C to +70°C (-40°F to 158°F)
Humidity Designed to meet or exceed the following:
• Bellcore GR63, Section 4.1
• Operating: 15%-90% (non-condensing) at 55°C (131°F)
• Non-Operating: 5%-95% (non-condensing) at 40°C (104°F)
Altitude Designed to meet or exceed the following:
• Operating: 4000 m (13123 ft))
• Non-Operating: 15000m (49212 ft)
Vibration Designed to meet or exceed the following:
• Bellcore GR-63, Section 4.4
• Operating: 1.0G, 5-500Hz each axis
• Non-operating: 0.5G, 5-50Hz; 3.0G, 50-500Hz each axis
Shock Designed to meet or exceed the following:
• DIN/IEC 60068-2-27
• Bellcore GR-63, Section 4.3
• 30G, half-sine 11ms, each axis