Kontron AT8904 - Manual (Page 17)

AT8904M Introduction
Page 1 - 4 AT8904M User Guide
• Routing protocols include
• OSPFv2
• RIPv2
• VRRP
• DiffServ
• ARP
1.1.2 General compliances
The AT8904M conforms to the following specifications:
• PICMG 3.0 AdvancedTCA Base Specification, Revision 2.0
• PICMG 3.1 Gigabit Ethernet for AdvancedTCA Systems, Revision 1.0
• AMC.0 AMC Base Specification, Revision 2.0
• AMC.2 AMC Gigabit Ethernet / 10 Gigabit XAUI Ethernet
• AMC.3 AMC Storage
• IPMI v1.5 Intelligent Platform Management Interface Specification
1.1.3 Optional Accessories
1.1.3.1 AMC
Two standard mid-size single width AMC bays for standard or custom AMCs are implemented.
AMC slots can be equipped with a
• Processor-AMC, e.g. acting as the system controller (saving one ATCA slot)
• HDD-AMC as mass storage device for the Processor-AMC
• Master Clock Generator AMC providing network synchronisation for telecom applications
• AM4310 Dual 10GbE Uplink AMC to enable multi-shelf AdvancedTCA systems (see
chapter 3.3)
1.1.3.2 RTM
RTM is optional. For further information on RTM, please refer to chapter 3.1.7.
1.1.4 Hot Swap Capability
The board supports Full Hot Swap capability as required by PICMG 3.0 R2.0. It can be removed
from or installed in the system while it is on (without powering-down the system). Please refer
to the PICMG 3.0 R2.0 specification for additional details.