Kontron CP6003-RC IPMI - Manual (Page 44)

IPMI Firmware CP6003-SA/RA/RC
Page 44 ID 1045-5656, Rev. 2.0
P R E L I M I N A R Y
15. IPMI and Hot Swap LEDs
On the CP6003-SA/RA, there are three LEDs controlled by the IPMI controller, two IPMI Status
LEDs and a Hot Swap LED. All three LEDs are located on the front panel of the CP6003-SA/RA.
On the CP6003-RC, there are two IPMI LEDs controlled by the IPMI controller. Both LEDs are
located on the rear side of the CP6003-RC.
The following figure illustrates the location of the two IPMI LEDs and the HS LED on the
CP6003-SA/RA.
HS LED
IPMI LEDs
I0 and I1
HS LED
CP6003-SA CP6003-RA
IPMI LEDs
I0 and I1